Pulsar PG8098 Guía para resolver problemas descargar pdf

SECTION B TROUBLESHOOTER’S GUIDE

PROBLEM

CAUSE SOLUTION

Insufficient water flow to

chlorinator

Check water flow through spray nozzles Clean spray nozzles with compressed air

Inlet Shutoff Valve closed Open Inlet Shutoff Valve

Emergency Shut Off Switch in closed position If ESS Valve is stuck, lower gently to reset

Solenoid Valve not operating properly Check with Dealer

Insufficient chlorine in pool Feed rate/output too low Increase feed rate/output on timer or ORP unit

Chlorinator empty Refill Briquette Tank with Pulsar

® Plus Briquettes

No/low inlet water flow See insufficient water flow section

Outlet Shutoff Valve closed Open Outlet Shutoff Valve

Clogged Discharge Tubing Refer to Section A or Replace discharge tubing

Briquettes stuck together Tap side of Briquette Tank to loosen

Clogged Briquette Tank Grid Refer to Section A

Clogged Venturi System Remove and soak in dilute Pulsar® Acid cleaner 50

Excess chlorine in pool Automatic Controller Problem Refer to automatic controller manual

Feed rate/output too high Decrease feed rate/output on timer

Air leaks Discharge Tubing not properly installed in fittings Reinstall Discharge Tubing

Discharge Valve seat failure Replace Discharge Valve Arm.

Scale prevents Discharge Valve from properly

seating

Remove Discharge Valve Assembly and soak in

dilute Pulsar® Acid Cleaner 50 to remove scale

Pinched O-rings in Tubing Connectors Inspect O-rings on discharge side of feeder

Chlorinator overflow Discharge Tubing clogged Refer to Section A or Replace Discharge tubing.

Insufficient outlet suction Check with Dealer

Emergency overflow switch failure Check with Dealer

1 2 3 4 5

Indice de contenidos

Pagina 1 - ® Plus Briquettes

SECTION B TROUBLESHOOTER’S GUIDE PROBLEM CAUSE SOLUTION Insufficient water flow to chlorinatorCheck water flow through spray nozzles Clean

Pagina 2

1IntroductionGeneral OverviewThe purpose of this guide is to familiarizeinstallation and maintenance personnel with theelectrical functions of the Pul

Pagina 3 - Timer Settings:

2Solenoid/Timer Assembly:The Solenoid/Timer Assembly consists of thetimer module which is plugged into the solenoidactuated water valve. Timer Mod

Pagina 4 - Troubleshooting Guide

3Troubleshooting Guide Step-by-step Electrical System Test1. Close water inlet and outlet valves2. Verify that the Power transformer is pluggedinto a

Pagina 5 - METER TEST

4METER TESTThe following tests should be performed utilizinga volt meter (ref. Fig.5 – detailed schematic &Fig.6 -- meter placement). The followin

Comentarios a estos manuales

Sin comentarios

Pulsar PG8098 Guía para resolver problemas

Busca en linea o descarga Guía para resolver problemas para No Pulsar PG8098. Pulsar PG8098 Troubleshooting guide Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para No Pulsar PG8098